EQUIPMENT SUPPORTED UNDER THIS PROGRAM:

• Trimble T10, Yuma, Kenai, Nomad
• Trimble RTS and RPT Robots
• Trimble Scanners (TX6, TX8, X7)
• Trimble SPS and R8s GNSS Receivers

SERVICES COVERED ON CONTROLLERS WITHOUT GPS (T10, Yuma, Kenai, Nomad)

• System Inspection – general physical damage inspection – test torque on external screws
• Verify and install most current operating system (subject to valid support agreement)
• Verify and install most current software version (subject to valid support agreement)
• Run diagnostic checks on touch screen, keyboard, battery, serial loop back, audio, backlight, and NAND memory
• Clean and calibrate touch screen
• Check connectivity to charger
• Check connectivity to Mobile Device Center
• SD and CF Cardport test
• Perform maintenance per any applicable service bulletin
• Check and record warranty status (per Trimble records)
• Check Bluetooth and Internal Radio where applicable

SERVICES COVERED ON GPS RECEIVERS ONLY (SPS RECEIVERS)

• R8s

All services listed above that are applicable, as well as:

• Verify and install latest GPS Firmware (subject to valid support agreement)
• Test all ports – test power and communication
• Perform LED test
• Receiver memory check
• Record RTK receiver frequencies – test internal radio
• Field Test GPS ensuring proper GPS reception
• Test and verify Bluetooth connectivity
• Verify and install latest Bluetooth and Radio Firmware
• Verify and test WIFI where applicable

BuildingPoint RAM Service also qualifies the unit as inspected and eligible for Trimble extended hardware warranties.

(*** certain exclusions apply, check with your local FPI Service department for details***)

Any additional services requested will be billed at regular rates.